24/7 Emergency Line · Water, fire, mold & storm damage

(619) 214-1229CA Lic #1038469

Water damage restoration FAQ

Water damage is our most common call, and it is the one where speed matters most. Here is how drying works and what decides what can be saved.

For active damage, call (619) 214-1229, any time.

How long does it take to dry a house after water damage?

Usually about three to five days. It depends on how much water there was, how long it sat and what got wet. Hardwood, plaster and concrete take longer. We don't go by the calendar. The job is done when the meter readings say the materials are dry.

What are the categories of water damage?

The industry standard (IICRC S500) sorts water by how contaminated it is:

  • Category 1: clean water, like a supply line or a tub overflow caught quickly.
  • Category 2: some contamination, like dishwasher or washing machine discharge.
  • Category 3: heavily contaminated, like sewage or floodwater from outside.

Clean water can turn into Category 2 or 3 the longer it sits.

Will you have to remove my drywall?

Not always. If the water was clean and caught early, we can often dry the wall in place by blowing air into the cavity. Drywall usually has to come out if it is contaminated, the insulation behind it is soaked, it has gone soft, or mold has started. When we do cut, we cut a couple of feet above the waterline to keep the repair small.

Can my hardwood floors be saved?

Sometimes. Hardwood dried quickly with floor drying equipment can often be saved, though some cupping may need sanding and refinishing. Floors that buckled, pulled away from the subfloor, or got contaminated water usually need to be replaced.

Can my carpet be saved?

Often, if the water was clean and it is dried quickly. The pad underneath is usually replaced. Carpet and pad soaked by contaminated (Category 3) water are thrown out because they can't be reliably sanitized.

How do you know when everything is dry?

We use moisture meters, map where the water went, and compare wet materials to dry ones in the same house. We record readings as we go so you and your adjuster can see the progress. The equipment stays until the numbers say it's done.

Why does the equipment have to run all day and night?

Air movers pull moisture out of materials and dehumidifiers pull it out of the air. Turning them off at night lets humidity climb back up, which slows drying and raises the mold risk. The noise is temporary, and we will place the equipment so you can live around it.

Will mold grow after a leak?

It can start within 24 to 48 hours if materials stay wet, so fast drying matters. We check mold risk on every water job. If mold is already there, we contain it and remove it as part of the job.

Do you fix the leak itself?

Our job is to stop the damage, dry the house and rebuild. Depending on the cause, the leak gets fixed by a licensed plumber or by us during the rebuild. We will tell you who is fixing what before work starts.

What if the water came from a slab leak?

Slab leaks often show up as warm spots on the floor, a water meter that runs with every tap off, or flooring that lifts. Once the leak is found and fixed, we dry the slab and the area around it and rebuild the damaged flooring, walls or cabinets.

About our 24/7 water damage restoration service

Damage happening now?

Call the 24/7 emergency line

Calling is the fastest way to get a crew out. Tell us what happened and we'll tell you the next step.

Call 24/7: (619) 214-1229